Cumulus Support

Hello
My internal temperature sensor after the batteries are discharged at the station shows a negative temperature at-50C. I started my station and let someone tell me where there is a temperature sensor, or what might be the cause of such indications. Uploaduję photos at this link. For 10-15 minutes should be all.

https://picasaweb.google.com/1129271971 ... Lutego2013

Please hellp me were is insdoor temperature sensor or where I fine schematic WH1080/1090

Hi,

Sorry, AFAIK the best (only) information about the FO Console is in this long thread. But I don't believe that anybody has traced the circuit diagram, nor even "found" the temperature sensor (it's perhaps combined with the humidy sub-panel). The external transmitter uses a blue "thermistor" but the Console possibly/probably uses a "bus" interfaced sensor (I2C, SPI, etc.).

Cheers, Alan.

Meybe when battery is low , console restart calibration settings in inside temperature.
Maybe i callibration inside temperature in cumulus or another program .

I have a similar problem with my WH1080. The indoor humidity has stuck on 85%. Temperature is alright, though. This also happened after a console reset.
But I haven't bothered with it, since indoors humidity isn't that important to me.

Cumulus not work when inside temperature is lowest in -50,0 C - When inside temperature is -49,0 cumulus data work but when temperature is -51 ; -60 ; -55 cumulus not work .
Now is -68,1 indside temperature http://scr.hu/0fqx/2biyx and cumulus don't see the station data.
http://scr.hu/0fqx/7glxg

Please tell me where change min display inside temperature for -55 ; -60 ; -70 etc.

Cumulus discards data from Fine Offset stations if the data is obviously bad, e.g. inside temperature below -50C (because the assumption is that the rest of the data will be suspect). There is currently no way to change this.

So now when station display inside temperature < -50,0 cumulus dont't be work and not save the data from the station
I must bay the console for WH 1090 ;((
Is not there some way to hard reset the calibration of the station or integrated circuit with a program?

Stevie,
When Cumulus be work if temperature inside is < -50 C ?

I can put it in the first beta of 1.9.4, but I don't know when that will be.

Ok thanks .

I've uploaded the beta. See https://cumulus.hosiene.co.uk/viewtopic.php?f=2&t=9433

Thank you very much. Everything works properly! beer
http://scr.hu/0fqx/46xz5