Cumulus Support

Today, My WS-1090 station stopped sending data to my laptop.
The following error messages appeared:

28/01/2013 20:50:41 : The station is not initialised
28/01/2013 20:50:41 : Byte 0 = FF Byte 1 = FF
28/01/2013 20:50:41 : Try resetting the console


All the sensors are working and all the expected data shows up on the console screen normally.

I have tested the console batteries: OK
I have pulled the batteries and allowed the internal battery to die. I then reinserted the 1.5.v cells and reset the values on the console screen.
Upon reconnecting the station and restarting Cumulus, the same error messages appear.

I even ran the Weatherwise program: ResetWS1090 but even tho' it stated that it had reset the "factory", no improvement occurred.

Are there any other things I can try to restore the data flow?

Try a Search for ws1090 and see if any of those discussions may be helful to you

Paul

When you did the reset, did you remove the batteries and the USB cable?

Have you seen this: http://wiki.sandaysoft.com/a/FAQ#When_I ... ialised.22?

The unit now works.(Yeah!)
What i had not done was to wait until the console screen went blank before running ResetWs1090.

This morning, I did wait and voila, everything works again.

As a result of my impatience yesterday, I lost 12 h of data. [However, the world will not tilt on its axis as a result.]