Cumulus Support

I'm looking at burrowing a RM Young TB to try out on my VP2. The advantage to this is that it tips at 0.1mm instead of 0.2mm. I know the console will display incorrectly (never look at it) but is it possible to tell Cumulus that each tip detected is now only 0.1 and not 0.2?

Duke

Put 0.5 in the rainfall multiplier calibration setting.

How does this interface with the VP2?

-Derek

http://www.alaskaweatherwatch.com

Grumpy Moose wrote:How does this interface with the VP2?

-Derek

Uses a reed, same as the VP2. So simply unplug the VP2 gauge, wire the new one with something like cat5 and fit an RJ11 (i think RJ11's have a different name in the states).

The bonus is it's more accurate and can be easily remotely mounted.

The one in the link comes with built in heater but, there is a cheaper version without.

Put 0.5 in the rainfall multiplier calibration setting.

Thanks Steve.

Duke

Awesome. Thanks! Maybe I will add this to my future upgrade list. I'm getting ready to wire up my RM Young 5103 anemometer to my VP2 for better accuracy, so it only makes sense to add the rain sensor someday.

I'll obviously need the heated version!

be sure to let us know how it works!

-Derek

http://www.alaskaweatherwatch.com

Grumpy Moose wrote:Awesome. Thanks! Maybe I will add this to my future upgrade list. I'm getting ready to wire up my RM Young 5103 anemometer to my VP2 for better accuracy, so it only makes sense to add the rain sensor someday.

I'll obviously need the heated version!

be sure to let us know how it works!

-Derek

I didn't know you could do that I assume you'll be letting us know how that goes? Soon.

Duke

duke wrote:I didn't know you could do that

Yep

http://www.davisnet.com/weather/product ... pnum=06336

Is it just me, not that I'm complaining, but is it not a little odd that Davis would develop a product to encourage you to use another manufacturers product?

Does any one know of a UK supplier for RM Young products?

This is supposed to be the UK contact but no website:

UNITED KINGDOM

READ SCIENTIFIC LTD
32 BRANCASTER WAY
SWAFFHAM
NORFOLK PE37 7RY
UNITED KINGDOM
Tel: + 441 760 724546 | Fax: + 441 760 724546
E-Mail: bill.read1@virgin.net

It's Norfolk. I don't think the internet has reached there yet.

RayProudfoot wrote:It's Norfolk. I don't think the internet has reached there yet.

Fair comment.

duke wrote:Is it just me, not that I'm complaining, but is it not a little odd that Davis would develop a product to encourage you to use another manufacturers product?

I gues I never looked at it that way. I kinda of figured it was like the whole Microsoft vs Apple thing. The more you open your syetm up to use with other products, the more business it generates. Anyway, I don't think I would say they are encouriging the use of other manufacturer's products. They certainly aren't promoting it very well. Very few people seem to even know about it.

While looking through the console set up today, I found the tip size screen actually has options for 0.1mm / 0.2mm and 0.1inch.

The manual has this to say:

Note: See the Integrated Sensor Suite Installation Manual for instructions on installing the
metric rain adapter. The 0.1mm setting does not provide correct rain measurements
with either the standard measurement or the metric adapter installed in the rain
bucket and should not be used.

Any one know any more about the 0.1mm option? Although the manual states not accurate with the VP2 bucket options I guess if it the RM bucket is connected and calibrated at 0.1mm the screen on the console should read correctly.

Derek, in case you missed THIS.