Cumulus Support

I was replacing my batteries on my temp sensor which worked out fine. then on my console i had to take out the batteries and insert them back in to activate the signal then on my cumulus the temp
read 21.1C and had 233mm of rain for the day. Is there a way maybe changing the batteries without getting the temp and rain spikes ?

My temp was -3.1c which is normal for the day not 21.1c a large spike also in the rain too which i had no rain at all.

Thanks Tony.

Before changing batteries, set up the spike removal to really low figures. That's probably easier than changing the neccessary files. Then once you've changes batteries, change your spike removal to your preferred settings. Put a note on the batt cover to remind you

MickinMoulden wrote:Before changing batteries, set up the spike removal to really low figures. That's probably easier than changing the neccessary files. Then once you've changes batteries, change your spike removal to your preferred settings. Put a note on the batt cover to remind you

Thanks M ickin

No worries I ceb