Cumulus Support

I have lost solar readings from my station, no sensor loss just light readings.

What is the reset button under the solar sensor for? and how do you use it, have read the manual and cant find any reference to it

If its the same as the WH3081 (I think it is bar the frequency used to transmit to the console) then it will reset the solar unit and the LED in the solar unit will blink initially then once every 60 secs.

After you press the reset button go to the console and place it in sensor discovery mode by pressing down button for more than 5 secs at which point you will see the receive signal indicator at top RHS of console on steady for a couple of minutes.

Eventually (within the minute hopefully) the console should display temp / humidity from outside unit and solar / UV if it is daytime else zero - not a dash. Dash means signal not received.

Point to note - the solar reset button also resets the temp / humidity unit.

Phil

Will give it a go then, thanks