Anemometer died

mraviator · Post by **mraviator** » Fri 16 Dec 2011 11:01 am

My Anemometer died after 1.5 usage. Either that, or it does not transmit wind speed or direction anymore.

Anybody else have this issue?

Charlie · Post by **Charlie** » Fri 16 Dec 2011 1:19 pm

wind speed and direction are 2 different sensors. If both are out you either have a cable cut or the transmitter is not working properly.

Tau Bootis · Post by **Tau Bootis** » Sat 17 Dec 2011 3:59 pm

Have you seen this thread.
https://cumulus.hosiene.co.uk/viewtopic.php?f=13&t=6345

mraviator · Post by **mraviator** » Mon 19 Dec 2011 11:50 am

Tau Bootis wrote:Have you seen this thread.
https://cumulus.hosiene.co.uk/viewtopic.php?f=13&t=6345

thanks. Looks like I have a different issue. Bearings are shot. Even lubing them does not work.

AllyCat · Post by **AllyCat** » Mon 19 Dec 2011 3:16 pm

Hi,

The bearing is a standard size (10mm o/d, etc.) so can be purchased for a few Pounds/Dollars/Euros from various suppliers, depending on your location.

Cheers, Alan.

ScottVan · Post by **ScottVan** » Tue 20 Dec 2011 4:13 am

AllyCat wrote:Hi,

The bearing is a standard size (10mm o/d, etc.) so can be purchased for a few Pounds/Dollars/Euros from various suppliers, depending on your location.

Cheers, Alan.

All bearings, all the time...use then for all thing RC controlled.

http://www.bocabearings.com/

Cumulus Support

Anemometer died

Anemometer died

Re: Anemometer died

Re: Anemometer died

Re: Anemometer died

Re: Anemometer died

Re: Anemometer died