Page 1 of 1
191 985 Series Delete: error
Posted: Thu 24 Mar 2011 7:45 pm
by n9mfk
Hi Steve,
just updated to 191985 got this error
3/24/2011 2:31:00 PM : Error reading C:\Cumulus\data\Mar11log.txt at line 32488: Series Delete: ValueIndex 0 out of bounds (0 to -1).
how can i fix this Beau
Re: 191 985 Series Delete: error
Posted: Thu 24 Mar 2011 8:15 pm
by steve
The error message is a bit misleading because there's nothing wrong with your log file. It's plotting the last 24 hours worth of data on the graphs, and for some reason the graph thinks it's trying to delete a point when there are no points on the graph. This code hasn't changed in quite a while. If you stop Cumulus and start it again, do you get the same error?
Re: 191 985 Series Delete: error
Posted: Thu 24 Mar 2011 8:28 pm
by n9mfk
Hi Steve,
no error after a restart
is there any thing else i should check?
Thanks Beau
Re: 191 985 Series Delete: error
Posted: Thu 24 Mar 2011 8:40 pm
by steve
It may just have been down to timing. Do your graphs look OK? How did you you notice the problem earlier, were you just looking at the error log?
Re: 191 985 Series Delete: error
Posted: Thu 24 Mar 2011 8:47 pm
by n9mfk
Hi Steve,
here are my graph
http://n9mfk.localweatherview.net/wxgraphs.php
when i started cumulus the red error light was blanking
Beau
Re: 191 985 Series Delete: error
Posted: Thu 24 Mar 2011 8:58 pm
by steve
Yup, looks OK.
when i started cumulus the red error light was blanking
Well, that's good, I suppose. It's possible that this does happen from time to time anyway, but I only recently changed it to flash the error light. I'll change it slightly to not flash the light for this error, and make sure that it goes on to draw the graphs.
Thanks.