Pressure adjustment

Rod Tibbs · Post by **Rod Tibbs** » Wed 19 Jan 2011 2:09 pm

At the moment the Met Office is giving pressure over almost the entire shouthern end of the country as 1032Mb. Cumulus is giving me a reading of 1023Mb.

If I assume that the Met Office is right and I am wrong, how do I adjust Cumulus to read the correct figure> Under Calibration/Pressure I have got 0.00 at the moment. Is this the spot where I do the correction and if so what figure should I put in to get the end results?

With thanks for any help,

Rod

nking · Post by **nking** » Wed 19 Jan 2011 2:17 pm

Shut down Cumulus, start Easy Weather and use the Setup under System to put in the actual relative pressure. The logger will then show the correct data for Cumulus to process.

Rod Tibbs · Post by **Rod Tibbs** » Wed 19 Jan 2011 2:28 pm

Thanks Neil,

I have done that and it worked!

Rod

Post by **steve** » Wed 19 Jan 2011 3:19 pm

You don't actually need to run EW for this; you can set it on the console.

nking · Post by **nking** » Wed 19 Jan 2011 3:34 pm

steve wrote:You don't actually need to run EW for this; you can set it on the console.

True - I just find it easier than trying to do it via the console, makes my fingers sore

Gina · Post by **Gina** » Wed 19 Jan 2011 5:15 pm

It's fiddly, that's for sure! But I'm not sure running EW isn't even fiddlier (if that's a word).

nking · Post by **nking** » Wed 19 Jan 2011 5:23 pm

Gina wrote:It's fiddly, that's for sure! But I'm not sure running EW isn't even fiddlier (if that's a word).

I think fiddlier may be a word but.... it is now!

When setting up you need EW for the log interval so we just need to remind people to do the relative pressure at the same time.

Cumulus Support

Pressure adjustment

Pressure adjustment

Re: Pressure adjustment

Re: Pressure adjustment

Re: Pressure adjustment

Re: Pressure adjustment

Re: Pressure adjustment

Re: Pressure adjustment