Page 1 of 1

sending unit not working

Posted: Sat 28 Aug 2010 9:59 pm
by slonesy
after of running for 2 years my weather stop sending after i change batteries
easy weather model 265 nc please help the red light flash every 25 sec
it has a dcf radio clock

Re: sending unit not working

Posted: Sat 28 Aug 2010 10:36 pm
by steve
Is the red light on the remote sensor flashing every 48 seconds? If so, it's probably working, but I believe there is a procedure which you can try to get the station to pick it up again. Unfortunately I cannot remember what you need to do at the moment, but hopefully someone will be able to advise.

Re: sending unit not working

Posted: Sat 28 Aug 2010 11:33 pm
by wd40
Mine is a newer one but this might help. Make sure you have the sensors up and running or hope they are. Take the batteries out of the console(receiver). Wait for a few seconds then put them back in. Do not touch any of the buttons till the console finds the sensor signal.

Make sure you are not too close. I think within 10 feet is too close.

Re: sending unit not working

Posted: Sun 29 Aug 2010 9:12 am
by Gina
And make sure the USB is disconnected or your console will get power that way. On the transmitter, you should get a long red light after putting the batteries in followed by a flash every 48 seconds. That's for the version without the DCF radio clock.