Cumulus Support

I have the Raspi pi zero 2w. I install the last image and cumulus does not start.
The following comes out with status:

juan@cumulusmx:~ $ sudo systemctl status cumulusmx
× cumulusmx.service - CumulusMX service
Loaded: loaded (/etc/systemd/system/cumulusmx.service; enabled; preset: enabled)
Active: failed (Result: exit-code) since Mon 2024-12-09 19:37:01 UTC; 23h ago
Duration: 18ms
Docs: https://cumuluswiki.org/a/Main_Page
https://cumulus.hosiene.co.uk/
Main PID: 598 (code=exited, status=217/USER)
CPU: 0

Dec 09 19:37:01 cumulusmx systemd[1]: Started cumulusmx.service - CumulusMX service.
Dec 09 19:37:01 cumulusmx systemd[1]: cumulusmx.service: Main process exited, code=exited, status=2>
Dec 09 19:37:01 cumulusmx systemd[1]: cumulusmx.service: Failed with result 'exit-code'.
l

Helppppp

Check if there are any logs in MXdiags folder, and attach them if you don’t spot anything obvious. I wonder if there was some limitations with dotnet8 and pi zero.

After a bit of googling, the error states that you are trying to run the service with an useraccount that does not exist. Did you remove or rename the default user in the image?

Does the CMX4 image work on the pi zero? I thought it needed beefier hardware.

freddie wrote: ↑Tue 10 Dec 2024 9:12 pm Does the CMX4 image work on the pi zero? I thought it needed beefier hardware.

I was wonderng about that also, but since the question concerns Pi zero 2, I’m not sure if that makes a difference. The error code suggests that it is not hardware related, but hopefully someone can verify this one way or another.