Page 2 of 2
Re: web tag errors after a refresh
Posted: Fri 05 Jan 2024 1:14 pm
by Stigian
Wrt the CPU temperature, we'll look at that later. It is caused because you run on a PC and not an RPi. This means that the Debian apparently is a slightly different dialect on a PC and requires a different method to access the CPU temperature. I am currently busy doing a lot of other things wrt CMX and personal so this will be much later. Sorry for that.
No problem Hans, already nice of you to respond so quickly. For completeness; I am using a virtual Linux environment which runs on my NAS.
Re: web tag errors after a refresh
Posted: Fri 05 Jan 2024 1:25 pm
by HansR
Stigian wrote: ↑Fri 05 Jan 2024 1:14 pm
Wrt the CPU temperature, we'll look at that later. It is caused because you run on a PC and not an RPi. This means that the Debian apparently is a slightly different dialect on a PC and requires a different method to access the CPU temperature. I am currently busy doing a lot of other things wrt CMX and personal so this will be much later. Sorry for that.
No problem Hans, already nice of you to respond so quickly. For completeness; I am using a virtual Linux environment which runs on my NAS.
Aha... you can work ahead in trying to find how to get the CPU temp if it is possible at all on that NAS. Just remind me in a few months
Re: web tag errors after a refresh
Posted: Fri 05 Jan 2024 2:28 pm
by Stigian
Hi Hans,
I see no way to access the parent hardware from this virtual environment. Then again what good does it do to know what the parent temperature is
Re: web tag errors after a refresh
Posted: Fri 05 Jan 2024 2:41 pm
by HansR
Stigian wrote: ↑Fri 05 Jan 2024 2:28 pm
Hi Hans,
I see no way to access the parent hardware from this virtual environment. Then again what good does it do to know what the parent temperature is
OK... than it would be only useful to remove that CPU temp from the list in your case.
Detecting the Linux dialect would than be the issue.
Re: web tag errors after a refresh
Posted: Sat 06 Jan 2024 11:44 am
by Stigian
Hi Hans,
You will need to either set the evapotranspiration values somewhere or calculate those through CMX (advised, personally I think the Davis values are far too high)
Requirment for CMX is the presence of a solar radiation sensor and the Vantage Vue lacks a Solar Radiation Sensor
Re: web tag errors after a refresh
Posted: Sat 06 Jan 2024 11:55 am
by HansR
Stigian wrote: ↑Sat 06 Jan 2024 11:44 am
Requirment for CMX is the presence of a solar radiation sensor and the Vantage Vue lacks a Solar Radiation Sensor
Ah yes... Did not think of that, sorry.
Ok, so you can remove the EVT charts from the site
