Page 1 of 1
Humidity zero
Posted: Thu 09 Nov 2023 3:13 pm
by Mapantz
I've just finished putting back my anemometer transmitter outside.
As I had the cable disconnected for a short period, the WLL doesn't send some packet data unless you power cycle the WLL. I closed CMX, then disconnected the power from the WLL, and removed the batteries for 10 seconds, then put them back in and connected the power. I waited for 2 or 3 minutes before opening CMX. I had the dashboard opened and saw the humidity drop to 0.
https://ibb.co/VpsDR2c
Re: Humidity zero
Posted: Thu 09 Nov 2023 6:08 pm
by freddie
It's likely that humidity was missing from a data packet - that would cause MX to use 0.
N.B: you can put images inline in a forum topic reply. I find imgbb a bit flakey - I couldn't access the image you linked to in your post.
Re: Humidity zero
Posted: Thu 09 Nov 2023 6:24 pm
by mcrossley
I think it more like it sends zero; if the data were missing it would flat line at the last value until a new value was received.
I don't suppose you had debug logging enabled at the time?
A spike setting would have prevented it.
The image in imgbb took ages to load for me, though it did eventually.
Re: Humidity zero
Posted: Thu 09 Nov 2023 7:28 pm
by ConligWX
Img loads fine for me. Attached....
relative-humidty-2.png
Re: Humidity zero
Posted: Thu 09 Nov 2023 9:53 pm
by Mapantz
I didn't have any logging on I'm afraid.
It registered in the realtime data going to the SQL table, but thankfully, CMX didn't register it as a 'low' figure, or the dew point either.
Re: Humidity zero
Posted: Fri 10 Nov 2023 12:41 am
by Mapantz
I just happened to look at the latest errors in the dashboard, and saw these:
Code: Select all
2023-11-09 14:46:42 - WL.com historic: Warning, no valid Solar data on TxId 1
2023-11-09 14:46:42 - WL.com historic: Warning, no valid Wind Chill data on TxId 1
2023-11-09 14:46:42 - WL.com historic: Warning, no valid Wind Chill (low) data on TxId 1
2023-11-09 14:46:42 - WL.com historic: Warning, no valid Dew Point data on TxId 1
2023-11-09 14:46:42 - WL.com historic: Warning, no valid Dew Point (low) data on TxId 1
2023-11-09 14:46:42 - WL.com historic: Warning, no valid Dew Point (high) data on TxId 1
2023-11-09 14:46:42 - WL.com historic: Warning, no valid Humidity data on TxId 1
2023-11-09 14:46:42 - WL.com historic: Warning, no valid Humidity (low) data on TxId 1
2023-11-09 14:46:42 - WL.com historic: Warning, no valid Humidity (high) data on TxId 1
Re: Humidity zero
Posted: Fri 10 Nov 2023 5:18 pm
by mcrossley
And those values would be expected on transmitter #1?