Page 4 of 4
Re: Extra Sensors Not Showing With Latest Build
Posted: Sun 12 Mar 2023 2:58 pm
by HansR
No errors detected or found in the log.
I can't find it uploading extratempdata.json (but e.g. tempdata.json is uploaded well).
extratempdata.json is not found on your site.
As it shows with outher users, that can only be explained if you did not (correctly) configure it to be used or did not configure the datafields. To me it still a configuration issue.
Re: Extra Sensors Not Showing With Latest Build
Posted: Sun 12 Mar 2023 3:08 pm
by The Dalek Hunter
Ok - thanks
So how do I configure it to be used?
As far as I am aware I have done nothing differently with the non working GW1000 setup than the working GW2000 setup
Something somewhere corrupted
Re: Extra Sensors Not Showing With Latest Build
Posted: Sun 12 Mar 2023 3:31 pm
by HansR
The Dalek Hunter wrote: ↑Sun 12 Mar 2023 3:08 pm
Ok - thanks
So how do I configure it to be used?
As far as I am aware I have done nothing differently with the non working GW1000 setup than the working GW2000 setup
Something somewhere corrupted
I don't think anything corrupted because than nothing would work I assume. This thread
started with a similar issue for your other site, I think you will have to work along those lines. If that does not work then hopefully others have additional (better) ideas.
Re: Extra Sensors Not Showing With Latest Build
Posted: Sun 12 Mar 2023 6:32 pm
by The Dalek Hunter
I have double checked everything and as far as I can see all is well. All that should be visible is set to visible!
The extra sensors are visible on the Dashboard but only AQ makes it to the website (I don't think lightning as yet can be viewed on the default website)
Both the Extra Temp and Extra Humidity do not.
I have set strings.ini so this extra sensor should be called "Hall"
In Trends this is till show as Extra Temperature and Extra Humidity but in Select-a-chart this is correctly called "Hall"
I have re-downloaded the latest version and copied it over CMX whilst it was not running. I have deleted all the files on my website and uploaded a fresh set.
Screenshot 2023-03-12 at 6.27.05 pm.png
Re: Extra Sensors Not Showing With Latest Build
Posted: Sun 12 Mar 2023 6:49 pm
by HansR
I'm lost. Somebody else?
Re: Extra Sensors Not Showing With Latest Build
Posted: Sun 12 Mar 2023 6:57 pm
by freddie
Cache? Have you tried opening your browser in an incognito/private window/tab?
Re: Extra Sensors Not Showing With Latest Build
Posted: Sun 12 Mar 2023 7:40 pm
by The Dalek Hunter
Well - not sure what I did but it is now working. I just unchecked all the graph file settings in the interval configuration and then checked them again, saved and rebooted.
Now it works!
Noticed that on both the GW1000 and the GW2000 sites in Trends the Graphs are still titled Extra Temperature and Extra Humidity whereas in Select-a-graph the have the titled as I have them set up in Locale Settings