Cumulus Support

Just wanted to say .... I think mine is working XD

... I guess I wont know for sure until tomorrow.

I realise there are the logs for viewing if there are problems but it would be nice to have a button in the UI that would do some form of health check of itself

Nossie wrote: ↑Wed 08 Mar 2023 7:41 pm I realise there are the logs for viewing if there are problems but it would be nice to have a button in the UI that would do some form of health check of itself

Thanks.

Something like the C1 short error log is on the ToDo.

Nossie wrote: ↑Wed 08 Mar 2023 7:41 pm Just wanted to say .... I think mine is working XD

... I guess I wont know for sure until tomorrow.

But what is 'working XD'?
Indeed it all seems to behave as expected.
[EDIT: No it doesn't... see ExtraSensor charts]

Strange. Could you make an issue in the CUtils thread and post the log for UserAskedData and the inifile?

I think the XD was Nossie trying to insert an Smilie!!

water01 wrote: ↑Wed 08 Mar 2023 11:51 pm I think the XD was Nossie trying to insert an Smilie!!

And there I thought Hans was being metaphorical

... what is 'working'? haha

Just to update I'm also having issues with extra sensors - applied the patch and I'm waiting until 10 am to see if the reports roll over.

Well .... hmmmm not sure what has happened here

[Edit:] Set the visibility again.

If it does not work, reinstall and take care all files are copied.

If that checked and still not working, you have to wait until Mark checks in.
(and we will continue with CUtils until this is fixed)

Nossie wrote: ↑Thu 09 Mar 2023 7:52 am

water01 wrote: ↑Wed 08 Mar 2023 11:51 pm I think the XD was Nossie trying to insert an Smilie!!

And there I thought Hans was being metaphorical

... what is 'working'? haha

Just to update I'm also having issues with extra sensors - applied the patch and I'm waiting until 10 am to see if the reports roll over.

No I wasn't, I guess David was right.

Think that's working again - I guess that's part of moving strings.ini into the interface.

will this have a knock on effect or is this just for display? (I noticed 'dashboard only' option


I notice the CO2 sensor temperature is not being displayed here and not listed under other sensors - can't remember if that was always the case.

WH45 Temperature 18.9 °C
WH45 Humidity 42 %

Nossie wrote: ↑Thu 09 Mar 2023 9:32 am will this have a knock on effect or is this just for display? (I noticed 'dashboard only' option

Not for CUtils if that was what you were referring to.

Nossie wrote: ↑Thu 09 Mar 2023 9:32 am I notice the CO2 sensor temperature is not being displayed here and not listed under other sensors - can't remember if that was always the case.

WH45 Temperature 18.9 °C
WH45 Humidity 42 %

I believe that has always been the case.

CO2 temp / Hum was never displayed here, but only on the CO2 graph. I have a bit of PowerShell script running to get it to display under a extra temp / hum sensor (in fact I was trying to get it under Sensor 10, and it wasn't working, but Mark has fixed the issue with this release).

I do have an issue with editing strings under the new Locale Strings page. Despite hitting save at the bottom of the page, and getting a pop up that it has saved, it doesn't seem to take effect.

I did see something mentioned about having issues with permissions on a pi - settings not saving, that might be one thing to consider.