Page 1 of 1
Cumulus MX and GW1100 - website does not update
Posted: Sat 21 Jan 2023 3:22 pm
by Waldi77
Cumulus MX and GW1100 - website does not update. Through localhost you can see that the data is received normally, meanwhile the server can only run manually. The WH-2080 station works normally with these settings. What could be the reason?
Regards
Re: Cumulus MX and GW1100 - website does not update
Posted: Sat 21 Jan 2023 4:53 pm
by PaulMy
Hi,
Your site seems to be updating at 5 minute interval for me. Your
http://www.pogodynka.pogodno.szczecin.pl/realtime.txt updates at about 30 seconds and Gauges also at the same interval.
Enjoy,
Paul
Re: Cumulus MX and GW1100 - website does not update
Posted: Sat 21 Jan 2023 6:15 pm
by Waldi77
This applies to this website:
www.meteo.pogodno.szczecin.pl
How to manually force update everything is ok.
I have set the update time to 5 minutes and unfortunately nothing changes.
This is what my settings look like (attachments)
Re: Cumulus MX and GW1100 - website does not update
Posted: Sat 21 Jan 2023 6:31 pm
by mcrossley
It helps to look in the MXdiags file. I suspect you have messages saying you do not have the minimum set of sensors (temp/press/wind).
If you have an incomplete station then this FAQ applies:
https://www.cumuluswiki.org/a/FAQ#Cumul ... that_I_set
Note however in CMX you can change that setting in
Station Settings | Common Options, you do not need to edit the Cumulus.ini file.
Re: Cumulus MX and GW1100 - website does not update
Posted: Sat 21 Jan 2023 6:43 pm
by Waldi77
mcrossley wrote: ↑Sat 21 Jan 2023 6:31 pm
It helps to look in the MXdiags file. I suspect you have messages saying you do not have the minimum set of sensors (temp/press/wind).
If you have an incomplete station then you this FAQ applies:
https://www.cumuluswiki.org/a/FAQ#Cumul ... that_I_set
Note however in CMX you can change that setting in
Station Settings | Common Options, you do not need to edit the Cumulus.ini file.
Thank you very much. Your answer solved the problem - I checked "no sensor check" and it's ok, the page is updating.