Temperature radio buttons

[AndyKF650]

Hi Hans

I am sure that the outside temp and inside temp radio buttons should be visible below the temperature gauge but for me this is not the case. I can see the coding in the index file and despite running a clean install or an overwrite install the buttons do not show.

Do you have any thoughts on this very minor problem?

BTW I upped the swap file on my RPi v4 from 100 to 1028Mb and will let you know if I see any problems.

[HansR]

I'll look into the cause of the radio button disappearance, my first peek at the code could not find why they would not appear.
The code for your gauge and the same on my site is equal. The strange thing is that the code for the radio buttons the there (view source of the page) but it does not work. Even worse: the code is there but I don't see it when I do Inspect of the element.

[EDIT:] when I look around I see that you are not the only one. Seems an issue with 6.7.8 but some others have the same issue
I miss what's wrong. I'll come back to this.

I assume your RPi4 has 4Gb of memory?
You might just as well up the swap then to 4Gb.
Btw is that 1028 a typo? Shouldn't that be 1024?

[mcrossley]

They are being removed by gauges with this...

Code: Select all

          if (!config.showIndoorTempHum) {
            $('#rad_temp1').remove();
            $('#lab_temp1').remove();
            $('#rad_temp2').remove();
            $('#lab_temp2').remove();
            $('#rad_hum1').remove();
            $('#lab_hum1').remove();
            $('#rad_hum2').remove();
            $('#lab_hum2').remove();
          }

[HansR]

Aha... Thanks Mark, that makes the route for me much easier, I hadn't found that yet. Apparently there is something in my code, which I messed up, with setting the config which sometimes does and sometimes don't.

Tomorrow the solution (I hope ).

[HansR]

OK, much simpler than I thought: it is not a bug it is a parameter !
Check the Wiki for the ShowInsideMeasurements parameter (must be true to show).

I must admit: I had forgotten all about this

[AndyKF650]

Hans

Thanks for that, what a simple fix! Change the .ini file run website and hey presto it works

I did look through the .ini file to see if the fix was there but obviously it was a "man look" and not spotted.

[HansR]

I did look through the .ini file to see if the fix was there but obviously it was a "man look" and not spotted.

Haha... yes I know what you mean. Happens to me all the time.