Cumulus Support

Hi I downloaded an created a new card with the latest RasperryPi image but it will not start CumulusMX.
I have stop service and restart service but no success.
Any other with some tips, please

Also tried to create a new card from scratch and installed mono and CumulusMX 3.14.1 3160 but still no success.

sudo mono CumulusMX.exe

Unhandled Exception:
System.IO.FileNotFoundException: Could not load file or assembly 'System.ServiceProcess, Version=4.0.0.0, Culture=neutral, PublicKeyToken=xxxxxxxxxxxxxxx' or one of its dependencies.
File name: 'System.ServiceProcess, Version=4.0.0.0, Culture=neutral, PublicKeyToken=xxxxxxxxxxxxxxx'
[ERROR] FATAL UNHANDLED EXCEPTION: System.IO.FileNotFoundException: Could not load file or assembly 'System.ServiceProcess, Version=4.0.0.0, Culture=neutral, PublicKeyToken=xxxxxxxxxxxxxxx' or one of its dependencies.
File name: 'System.ServiceProcess, Version=4.0.0.0, Culture=neutral, PublicKeyToken=xxxxxxxxxxxxxxx'

Thanks

did you install the latest version of mono ?
sudo apt-get update
sudo apt install mono-complete

Thanks for the tips.

I installed only de utils for mono not the complete set.

Now it works so far.

Happy New Year 2022.

http://privat.bahnhof.se/wb815306//weather/index.htm

It did cross my mind to suggest this - but I thought the whole point of the image was to have everything in it necessary to run MX. Perhaps I have the wrong end of the stick about the images?

They should be a ready to go image - When I have tested them CMX runs without having to install anything else.

mcrossley wrote: ↑Tue 28 Dec 2021 11:15 am They should be a ready to go image - When I have tested them CMX runs without having to install anything else.

Yeah that's what I thought. Which makes the answer from @sm0ifp a bit of a puzzle. Perhaps it was a re-install rather than a fresh install?

If I remember correctly, there could be some issues, if Mark creates the image with RPi 3B or newer, and then one tries to run it with an earlier board. That would be somehow related to cpu architecture and the fact that some parts of mono-complete are compiled during installation… And if this occurs, it could be repaired by uninstalling and reinstalling mono. But all this with a huge disclaimer, information is based on some faint memories, no hard facts to back it up.

I think the only board that will have issues is the Zero which uses a different CPU family, and maybe some very old first generation boards.

The 4 should be ok, but it will run as a 32 bit OS of course, not that there is much to be gained from 64 bit.

I am using the first version of RaspberryPi 1.

Using CumulusMX and aprx on the device and it use to work well if I tweek some of the applications.


Thanks.