Cumulus Support

I had switched my Logging Extra Sensors to off.
Then I changed something in the AirLink configuration and saved that (the IP address). That apparently did switch Logging Extra Sensors to on.
(I have no other explanation for what happened).

I think this is erroneous and confusing because the Airlink has its own logfile and its own on/off switch.
So even when falling under the menu Extra Sensors, the AirLink parameters should not influence the Logging Extra Sensors on/off switch.

Its not enabling AirLink that switches extra logging on, but enabling either of the HTTP protocols.

Now I admit it just enables the logging no matter which sensors you select and that could be refined as not all the available options will log in the extra file.

mcrossley wrote: ↑Sun 03 Oct 2021 10:16 am Its not enabling AirLink that switches extra logging on, but enabling either of the HTTP protocols.

OK.

mcrossley wrote: ↑Sun 03 Oct 2021 10:16 am Now I admit it just enables the logging no matter which sensors you select and that could be refined as not all the available options will log in the extra file.

Right, logfile dependent!
And maybe keeping those on/off choises together (either on program level or on extra sensor level)

Thnx