Check operating of station via SSH

ChaserPeek · Post by **ChaserPeek** » Wed 17 Mar 2021 6:33 pm

Hi guys,

I would ask if it exist a solution to check input data packet without web interface of CumulusMX.
Example: If I have a low battery in ISS or I have a bad receiving performance, or I have a bad connection with USB interface. Maybe can be usefull to check if all data packet are correctly in.

Exist a tool or a file to check ?

Thanks.

forestedge · Post by **forestedge** » Wed 17 Mar 2021 7:40 pm

Hi
You can check data packets through the VP2 console diagnostic screen. Details are from page 38 of the VP2 manual. https://www.davisinstruments.com/produ ... _06312.pdf

ChaserPeek · Post by **ChaserPeek** » Wed 17 Mar 2021 7:49 pm

Thanks Forestedge.
it's good if I have the display near, but if I have a remote station ?

philpugh · Post by **philpugh** » Thu 18 Mar 2021 11:17 am

Have a look at the Webtags in the Cumulus wiki (https://cumuluswiki.org/a/Webtags).

Towards the end (https://cumuluswiki.org/a/Webtags#Davis) there is a section about data available from DAVIS systems. Battery sensing is amongst these.

The beginning of this wiki describes the methods available to read this data.

ChaserPeek · Post by **ChaserPeek** » Thu 18 Mar 2021 1:29 pm

Thanks Phil, I will take a look

Cumulus Support

Check operating of station via SSH

Check operating of station via SSH

Re: Check operating of station via SSH

Re: Check operating of station via SSH

Re: Check operating of station via SSH

Re: Check operating of station via SSH