Problems to configure CumulusMX

[paologambal]

I installed the program as per your site and I connected the Oregon WMR928nx station on the rs-232 port but unfortunately it does not connect. When I go to run sudo mono on the terminal it gives me the following errors that I send them. If you can help me, thank you. Regards.

[ConligWX]

if you care to look at the screen shots you have posted it says Specified port number not open.

find out what com port your serial is plugged into and assign that in the Cumulus.ini

Code: Select all

ComportName=xxxxxxxx

[HansR]

You are running build 3042, that is very old. I would advise to upgrade.
And while you are at it, please check the versions status of Mono and Linux as well.

The most likely cause is rooted in version incompatibility.

[water01]

You are running build 3042, that is very old. I would advise to upgrade.
And while you are at it, please check the versions status of Mono and Linux as well.

The most likely cause is rooted in version incompatibility.

How on earth does someone get hold of build 3042, that is while Steve was still doing the builds!!

[freddie]

How on earth does someone get hold of build 3042, that is while Steve was still doing the builds!!

It's 3043 but it's still ancient and should be trying a newer version

[PaulMy]

How on earth does someone get hold of build 3042,

You want it

Enjoy,
Paul

[HansR]

How on earth does someone get hold of build 3042, that is while Steve was still doing the builds!!

Collectors item!

[paologambal]

On the raspberry Pi 2 reinstalled Raspbian buster vers. 2020.8.20 Desktop and CumulusMx 3.8.3 distr.3093 but I am still having problems updating CumulusMX from the Oregon Wmr928 station (serial port rs232 to usb port of the raspberry). of the screenshot of the station errors. Thank you if someone can help me.

[ConligWX]

if you care to look at the first screenshot.

it says near the bottom:

Code: Select all

An error has occurred - please zip up the MXdiags folder and post it in the forum.

Where is your zip file?

can you post the output of this command:

Code: Select all

dmesg | grep tty

[paologambal]

sending zip file

[paologambal]

Tonight I tried to install CumulusMX version 3.0.0.0 build 3044 but to my surprise I am again with problems that I post with screenshots.
Thanks for your help.

[freddie]

Something else on your Pi listening on port 8998?

[mcrossley]

We go right back to the first response above which you have not really answered.

What are you entering in Cumulus MX as the serial port name?

[paologambal]

What do you mean by serial port name? tcp port? on the configuration of the oregon? The number 22222 is entered.

[ConligWX]

I think he means the name of the comport entry in cumulus.ini

like so:

Code: Select all

ComportName=/dev/ttyUSB0

or

ComportName=COM1