Page 1 of 1
Station is not initialised....???
Posted: Tue 15 Sep 2020 11:29 pm
by bnwrx
This came up a few hours ago on Cumulus 1......I've never seen this before.....Cumulus has been running all day just fine until about 3 hours ago....
Also Cumulus displays this..." Try resetting the console"....again any ideas?"
Thanks for any help....
Update:after rebooting my computer and rebooting the station console, the console info is being displayed correctly by Cumulus, but I keep getting an error for "ignoring high hourly rain rate"....???
Re: Station is not initialised....???
Posted: Wed 16 Sep 2020 12:03 am
by TRB
Not seen that error with my Cumulus 1 but over the years I've had a few apparent station lockups.
The only solution for me has been stop Cumulus, reboot the station console/hardware and run Cumulus. Works every time.
Whoops... you edited yours after my post.
Re: Station is not initialised....???
Posted: Wed 16 Sep 2020 12:13 am
by bnwrx
thanks for your response....yea, I did get it running with the 2 re-boots, but now it keeps sending that other error as I posted above....
strange happenings, I've had Cumulus for 12-15 years, been VERY reliable.....
Re: Station is not initialised....???
Posted: Wed 16 Sep 2020 5:53 am
by ConligWX
Running software for 12+ years and then trying to diagnos a fault would be pretty hard without some information.
Are there any log files to go with the events? If it's ignoring the hourly rain rate, is the station giving out erroneous data perhaps?
Re: Station is not initialised....???
Posted: Thu 17 Sep 2020 4:47 pm
by bnwrx
UPDATE: Its been 2 days since re-booting the station console and re-booting Windows 10....no problems since....just like its been for all these years.....??
Thanks for your inputs...