No ack received in response to LOOP 20 error

G6GUH · Post by **G6GUH** » Mon 24 Aug 2020 5:06 pm

Hi, updated this morning to build 3092 and now have this error..No ack received in response to LOOP 20 error...It has only appeared with this build, build 3091 was a full install so all of the files are up to date.

mcrossley · Post by **mcrossley** » Mon 24 Aug 2020 9:56 pm

Can you enable debug and data logging in the station settings, let it run for 10 minutes then post the log file again please.

G6GUH · Post by **G6GUH** » Tue 25 Aug 2020 7:15 am

this mornings MXdiag file

hope it makes sense

http://www.cardingmillweather.co.uk/MX/

mcrossley · Post by **mcrossley** » Tue 25 Aug 2020 10:01 am

You have enabled the force barometer 1 minute updates, but you are running firmware 3.80.

The force updates is really meant for old VP stations, or VP2's with very old firmware which only updated the pressure reading every 15 minutes.

I just tested the command on my VP2 and there is quite a long pause between the OK, and the baro reading which my streamlined protocol code is not coping with as it should

For now please disable that setting - it is doing nothing for you anyway - and I'll fix the code.

G6GUH · Post by **G6GUH** » Tue 25 Aug 2020 10:09 am

Thanks, changed and will reboot and see how it works

Regards Pete

G6GUH · Post by **G6GUH** » Thu 27 Aug 2020 11:15 am

All working fine now.

Thanks Pete

Cumulus Support

No ack received in response to LOOP 20 error

No ack received in response to LOOP 20 error

Re: No ack received in response to LOOP 20 error

Re: No ack received in response to LOOP 20 error

Re: No ack received in response to LOOP 20 error

Re: No ack received in response to LOOP 20 error

Re: No ack received in response to LOOP 20 error