Cumulus Support

Updating after _quite_ a while. I extracted 3.8.2 right over the top of my version 3.2.6. After some poking around I noticed the latest version did not display dewpoint.
I thought I did something wrong or it had been too long (and needed to do some multi-step upgrade process). Decided to take a backup and do a fresh install and reconnect to my WLL. Fresh install connecting to WLL (using automatic discovery) still doesn't show a dewpoint. When I roll back to the old version I get dewpoint. I'm wondering if maybe I found a bug?

Hi there.

I have a WLL and running the 3.8.2. Due Point working here just fine.

I would however suspect coming from 3.2.6 and going straight to the latest would cause some issues.

My WLL calculates/shows dew point on v3.8.2 as well.

I'd like to see a run of 3.8.2 started with the -debug command line parameter and the resulting log file.

It sounds like you didn't copy over your Cumulus.ini file from 3.2.6 to the 3.8.2 folder, any reason for that? Re-read, your post, I see why.

I have found the issue, the dew point threshold limit (default 40C) is applied to installations configured to use Fahrenheit as if it were a Fahrenheit value.

As a work around please set your dew point limit value to 999 in the calibration settings until I get a patch pushed out.

Perfect. Thank you! That did the trick. Never even would have looked there. If I had done the upgrade in the Winter that problem would have taken much longer to crop up.

Running as a service now, too. Thank you for adding that!