Oregon WMR928NX

kranich · Post by **kranich** » Sun 10 May 2020 3:03 pm

Hello. My external temperature sensor THWR288 does not display the temperature in Cumulus MX (all versions), it even causes a complete stop of the whole program and it stops updating the measured values. Everything is fine on the weather station display and in the older version of Cumulus 1 everything also worked. I also have another external temperature and humidity sensor connected, but everything is fine. Does anyone have a similar experience?

mcrossley · Post by **mcrossley** » Mon 11 May 2020 9:18 am

You need to start MX with the -debug command line parameter, and then zip up and attach your MXdiags folder.

kranich · Post by **kranich** » Tue 12 May 2020 9:17 am

I'm sending files

mcrossley · Post by **mcrossley** » Tue 12 May 2020 3:54 pm

Those logs have not been run using the "-debug" parameter so there is nothing in them for me to look at.

kranich · Post by **kranich** » Tue 12 May 2020 10:44 pm

Is that it?

mcrossley · Post by **mcrossley** » Wed 13 May 2020 11:46 am

OK, I see the problem, MX is missing a bit of configuration required to decode the Extra Temp only devices. The result is it then reads the data forever (until MX crashes) without decoding any more data.

I'll have to fix this in the next release.

kranich · Post by **kranich** » Wed 13 May 2020 4:53 pm

Thank you very much

mcrossley · Post by **mcrossley** » Sat 16 May 2020 1:50 pm

PM sent last Thursday?

mcrossley · Post by **mcrossley** » Mon 18 May 2020 9:48 pm

I understand that you are only getting one extra temperature sensor logged, when you expected two - is that correct?

Cumulus Support

Oregon WMR928NX

Oregon WMR928NX

Re: Oregon WMR928NX

Re: Oregon WMR928NX

Re: Oregon WMR928NX

Re: Oregon WMR928NX

Re: Oregon WMR928NX

Re: Oregon WMR928NX

Re: Oregon WMR928NX

Re: Oregon WMR928NX