Page 1 of 1
Switch from one version to another
Posted: Fri 01 May 2020 9:52 am
by Nevizio
I have to install cumulus mx in another pc but I want to keep all the data that I had in cumulus mx in the previous pc, now the problem is that in the previous pc I had version 3.2.4 b3060 while the current one (which I will install) is v3.5.4 (build 3075)
How you do it? (step by step)
Re: Switch from one version to another
Posted: Fri 01 May 2020 11:01 am
by Nevizio
Then I managed it alone but I don't see the graphs the rest works all this the procedure I did: installed the latest version on the new PC and copied and overwritten the following folders / files
Data, Reports, Cumulus.ini CumulusMx.exe.config
Re: Switch from one version to another
Posted: Fri 01 May 2020 11:22 am
by mcrossley
Where do you not see the graphs, in the admin interface or the web page?
If your web page, then a link to it will help. Either way it would be useful to zip up your MXdiags folder and attach that.
BTW, you should not copy the CumulusMX.exe.config file - that can be specific to the version of MX.
Re: Switch from one version to another
Posted: Fri 01 May 2020 12:17 pm
by laulau
There might be some files to upload to your web site if it's there the graphs don't work!
And clear the browser cache should also help in some case !
Re: Switch from one version to another
Posted: Fri 01 May 2020 12:53 pm
by Nevizio
I simply had not seen the news of the release with build 3071
, now I have reconnected the pc to internet and I see the graphs, I noticed that in the new release the data visualization in the datalogger can only take place through 10 lines at a time, while in the past there was the comfortable display of up to 100 lines at a time
