Page 1 of 1
Change battery in Davis Vantage Vue
Posted: Fri 10 Apr 2020 11:48 am
by madsandrup
Hello,
I'm soon going to change the battery in my Vue. I can stop CMX, but the logger in console will continue to store readings.
Is it possible to avoid "fake" readings to be logged during the maintenance?
Regards,
Mads
Re: Change battery in Davis Vantage Vue
Posted: Fri 10 Apr 2020 1:48 pm
by dazza1223
not as i know no!!!
Re: Change battery in Davis Vantage Vue
Posted: Fri 10 Apr 2020 2:37 pm
by PaulMy
The ISS battery can be changed without interference or interruption of transmission.
The Vue console can run on batteries, wall power or both, so changing the battery while still plugged in will not affect reception. From the Davis Vue manual:
Console Maintenance Changing Batteries
If the message, LOW CONSOLE BATTERIES appears in the Weather Center, replace the batteries.
1. In order to avoid losing any stored weather data, plug in the AC adapter before removing the batteries. Note: If you cannot plug in the AC adapter, enter Setup Mode by pressing and releasing 2ND and pressing SETUP. Entering Setup Mode makes sure the station isn’t writing any data to memory when power is removed.
2. Remove the battery cover located on the back of the console by pressing down on the two latches at the top of the cover.
3. In the top battery compartment, insert a fingertip between the battery and the notched end of the compartment and remove the battery.
4. Repeat the process for the batteries in the bottom battery compartment.
5. Install the new batteries. (See “Installing Batteries” on page 3.)
6. Replace the battery cover and remove the AC power adapter, if desired.
Enjoy,
Paul