Cumulus Support

Hi,
from yesterday night have problem with CumulusMX webinterface... Before all working well, but now...
Setup menu is blank, and other links make err

Any idea ?

Is it possible that your system settings have changed? In particular something like the decimal separator?

steve wrote:Is it possible that your system settings have changed? In particular something like the decimal separator?

The system run 5days continuously without err... All run in the table, PC without network connection... Any change is not possible...
And now... This... I dont know, what is happend :/ Also not read values from WX

If you zip up the mx diags folder and attach it, I'll take a look. There may be something in there which helps.

any Ad blocker extensions on your web browser that maybe blocking content?

steve wrote:If you zip up the mx diags folder and attach it, I'll take a look. There may be something in there which helps.

Here is https://we.tl/TuhQQgIDkw full folder, I dont know, whitch files you want... But I test unzip original files and replace, no change

Toxic17 wrote:any Ad blocker extensions on your web browser that maybe blocking content?

I test connect to main PC with CumulusMX from other PC and the same...

Something has happened on your system, Cumulus thinks you only started using it today. You have no data logs. I'm afraid I can't say more than that.

Problem solved.... I dont know why, before RUN on W7 CZ location... But after change to US location, working well..

Thank you for help !

Hello, the same problem. Last check of system yesterday night. Everything was ok. The only action before - Raspberry pi power source exchange.
When I start CumulusMX, the status is Connected to station. But no data presented to the web and I´m not able to reach Station Settings. No configuration change in between yesterday night and morning today. But I'm unable to properly start Cumulus.

Raspberry pi 3, mono version 4.6.2, weather station Davis VP2, datalogger by belfryboy

Any idea?

If you zip up the MXdiags folder and attach it to a reply, I'll take a look.

Attached to previous post.
I went through it and I have found message "Error at line 2832 of data/srp18log.txt : Input string was not in a correct format." It seams to me like some data corruption. But what I'm confused about - I have tried to run totaly new instance and in this case message "station type not set" is shown but again I can't enter Station Settings section.

Sorry, I can't extract the files from that archive on my PC. But from that message, it looks like your system settings have changed, i.e. you are now running under a different locale with different settings, so existing data formats aren't recognised.

Tried to add once more.
There was some change but 2 or 3 days before and everything worked good. Ok, I can try "clear installation". Can you give me some hint how to do that (link to theme in forum or something like that)? I tried new installation into another folder - no old files moved into this destination - but still, I'm not able to run configuration of station.
Thanks a lot! Hynek

You seem to be concatenating the diags files into a single file, and they're in reverse chronological order or something. Makes them very difficult to look at! There only seem to be files from today. I wanted to look at older files and compare them with the recent ones, to see what has changed regarding your locale. But I'm sure that's the problem, you need to go back to how you were running Cumulus previously.