Page 1 of 1
Cumulusmx
Posted: Tue 30 Aug 2016 9:30 am
by The PIT
Just installed this and noticed that the leaf wetness isn't working correctly. It's showing 15 when it should be zero. It never worked properly under cumulus one either but since development had stopped on this I didn't bother reporting it.
Davis vantage vp2 the other extra sensors are fine. Basically the leaf wetness are duplicates of sensor 1
Re: Cumulusmx
Posted: Tue 30 Aug 2016 9:35 am
by steve
Turn on debug logging and data logging, let it run for a couple of minutes, then attach the latest MX diags file, and I'll take a look.
Re: Cumulusmx
Posted: Tue 30 Aug 2016 6:53 pm
by The PIT
Strangely cumulusmx seemed to be doing some logging before I turned it on. I turned logging on after 19:30. Anyway here's the logging.
Re: Cumulusmx
Posted: Tue 30 Aug 2016 7:15 pm
by steve
Can you show me a screen shot of where you're seeing this? I can see that your leaf wetness 1 figure is indeed zero, but having looked at the code, it's not immediately obvious where the problem is. What is being put in the extra data log for the leaf wetness values?
As an aside, are you using Virtual VP? You're not getting any response to requests for LOOP2 packets. If you are using Virtual VP, you should disable LOOP2 packets as mentioned in the instructions.
Re: Cumulusmx
Posted: Wed 31 Aug 2016 6:21 pm
by The PIT
here we go
cumulus incorrect data.jpg
Re: Cumulusmx
Posted: Wed 31 Aug 2016 6:33 pm
by steve
I'm confused. You said it was showing 15 when it should be showing zero, but in your screen shot it's showing zero?