pressure not updating

[techguy30]

pressure does not seem to be updating in mx its locked at 1006.2 mb

on the console it says 995.3mb

[steve]

Are you sure you are looking at the same reading on the console and in Cumulus? See http://wiki.sandaysoft.com/a/FAQ#Cumulu ... et_console

If the reading in Cumulus really has frozen, do you have a spike removal setting for pressure? If so, it may be too small.

If none of the above apply, zip up the MXdiags folder and attach it, and I'll take a look.

[techguy30]

i can set a spike removal. it currently at default which is 999

[steve]

That eliminates the spike removal setting as a cause for your perceived problem. What about the other point as in the FAQ?

[techguy30]

im looking at complete different readings to the console than in mx

here is my diags

[steve]

im looking at complete different readings to the console than in mx

Yes, that's the whole point, as mentioned in the FAQ. You are looking at the absolute pressure on the console, and the relative (sea-level) pressure in Cumulus.

2016-02-12 12:49:49.837 Rel pressure = 1012.8
2016-02-12 12:49:49.837 Abs pressure = 995.1

You need to set the relative pressure on your console and only look at that.

You also seem to have a problem with your console, Cumulus is having trouble reading data from it:

2016-02-12 12:57:00.527 *** Data input appears to have stopped

Make sure you have no USB power saving settings, check USB cables etc.