Page 1 of 1
CumulusMX Raspberry Pi configuration problem - JS error
Posted: Mon 11 Jan 2016 9:59 pm
by maryl16
Hello,
I have WT1080 station, I plugged it into the Raspberry Pi 2, unfortunately I can not make configuration. When attempting to save the station model on the configuration page displays the JS error "error [object Object]". I do not know what I'm doing wrong. Browsers turned on support for the JS. I ran out of ideas for solving this problem. I've tried different versions of Mono.
Regards
-maryl16
Re: CumulusMX Raspberry Pi configuration problem - JS error
Posted: Tue 12 Jan 2016 8:10 am
by steve
Assuming that you are using the Polish locale, this would normally happen with Mono 3.2.8. Have you definitely installed Mono 4.0 and done a mono -V to confirm it?
Re: CumulusMX Raspberry Pi configuration problem - JS error
Posted: Tue 12 Jan 2016 12:01 pm
by mauro
Hello!
I am writing you from Italy.
I installed CumulusMX on Raspberry Pi. I can not update Mono 4.
Can you explain me how can I do that? Can you send me all the steps?
Thank you very much
Bye bye
Re: CumulusMX Raspberry Pi configuration problem - JS error
Posted: Tue 12 Jan 2016 12:06 pm
by steve
I installed 4.0 on my Pi by adding the following line to /etc/apt/sources.list
deb
http://plugwash.raspbian.org/mono4 jessie-mono4 main
and then doing an apt-get update and installing mono-complete. That assumes you're using Jessie and not Wheezy. I'm not sure what you do if you're using Wheezy.
Re: CumulusMX Raspberry Pi configuration problem - JS error
Posted: Tue 12 Jan 2016 12:20 pm
by richard_newberry
Why did you update Mono to 4.0 from 3.2.8 Steve? Just curious thats all?
Re: CumulusMX Raspberry Pi configuration problem - JS error
Posted: Tue 12 Jan 2016 12:22 pm
by steve
To test it, for those who need to use it, on my spare Pi.