Cumulus Support

Hi, I just installed the latest version of cumulus mx in a raspberry pi, I can not configure the station via the Web interface , I 'm editing the " cumulus.ini " file , but I get to put the port for a season "fine offset "
Can anyone tell me what port should I put ?
Weewx is that using this in the next usb / dev port / bus / usb / 001/ 004 , but not equivalent to com port

Greetings and thanks

Fine Offset stations don't use a serial port, they are USB.

Why can't you use the user interface - what happens? What version of Mono are you using, and what locale?

I installed the mono complet, in the web interface when i push the save botom the error is "error object" and when i start cumulus says "fine offset " not found

ea1htb wrote:I installed the mono complet

Yes, but which version? What does mono -V show? And what locale are you using?

then when I get home I'll show you all data, greetings and thanks

Hi, I am using the version 3.2.8 of mono, and the locale is Spain.

Thanks

You won't be able to use that version of Mono with a Spanish locale, which is why the user interface isn't working. You will need to install 4.0 - make sure you don't install 4.2, because that won't work with your station.

ok , but I should install version 4.0 is mono or cumulus mx , what is the link?

Thank you

I installed 4.0 on my Pi by adding the following line to /etc/apt/sources.list

deb http://plugwash.raspbian.org/mono4 jessie-mono4 main

and then doing an apt-get update and installing mono-complete. That assumes you're using Jessie and not Wheezy. I'm not sure what you do if you're using Wheezy.

Hello I have followed the steps in this post " https://cumulus.hosiene.co.uk/viewtopic.p ... 5&p=113229 " and I still installing the version 3.28 , I'm using the version wheezy