No "Wind Run"

[gwheelo]

I am operating two weather stations. One an Oregon WM-88. The other a WMR968. This allows me to use the WMR-968 to collect wind data only.
I am just becoming familiar with CumulusMX and have successfully accessed (seperately)both weather stations with MX.
When accessing the WMR-88 all data displays without a problem in the HTML interface and all data is FTPd without incident.
The WMR-968 station provides only wind data as the other sensors are not in operation. This has never been a problem with Cumulus 1. All wind data displays correctly and is transmitted via FTP. However when using CumulusMX the WMR-968 wind speed and bearing information displays correctly but "Wind Run" data displays as "0" and "0" is transmitted via FTP.
Is there soething that I have not set in MX or is there some other problem
gwheelo

[steve]

As you presumably don't have an outdoor temperature reading, you will need to override the check on that as in this FAQ - http://wiki.sandaysoft.com/a/FAQ#Cumulu ... eb_uploads

Normally you would need that setting for web updating to take place, but that depends on the interval that you've set.

[gwheelo]

Hello Steve -

As always "spot on." Working perfectly. Never occurred to me as wind speed, direction, etc. was OK - Wind run is, of course, a running calculation.

gwheelo