Cumulus Support

Sorry to start a new thread, but I haven't be able to resolve my issue. I have recently made the mistake of restarting Cumulus while my temp/hum sensor was disconnected from the ISS transmitter, and therefore "----" were appearing on the console at the time . This caused the associated numbers (temp, hum, chill, dew, etc.) to read "0" on Cumulus until I reconnected the sensor a few mins later. There was no error in the logged data/records in Cumulus but when I looked at the outside temp graph, there was a spike from about 45ºF down to 0ºF and right back up again. Is there any way to remove the spike on the graph? I've added a spike removal, but it didn't change anything. And like I said, there are no errors in the dayfile.txt or other records anywhere.

Spike removal doesn't change anything retrospectively, and doesn't apply to Davis stations anyway. If restarting Cumulus doesn't correct the graph, then the values are in the January log file, so you would need to edit that, with Cumulus stopped.

I found it and fixed the issue. Thanks!