Sorry to start a new thread, but I haven't be able to resolve my issue. I have recently made the mistake of restarting Cumulus while my temp/hum sensor was disconnected from the ISS transmitter, and therefore "----" were appearing on the console at the time
. This caused the associated numbers (temp, hum, chill, dew, etc.) to read "0" on Cumulus until I reconnected the sensor a few mins later. There was no error in the logged data/records in Cumulus but when I looked at the outside temp graph, there was a spike from about 45ºF down to 0ºF and right back up again. Is there any way to remove the spike on the graph? I've added a spike removal, but it didn't change anything. And like I said, there are no errors in the dayfile.txt or other records anywhere.
