Cumulus Support

my nana told me Anemometer is still spining the hight about 4.5m and shows 0.0kph? i need help please anyone know how i fix it?

It's not clear whether the console is showing zero or just Cumulus? Either way, the Cumulus Wind Multiplier isn't going to help.

Cumulus is not showing the wind but wind direction is changing

But is the console showing the wind speed as zero as well?

nope

Then your anemometer is faulty. Perhaps the reed switch is stuck.

steve wrote:But is the console showing the wind speed as zero as well?

WXstevo wrote:nope

No the console isn't showing zero? Or no the console is showing zero?

mcrossley wrote:No the console isn't showing zero? Or no the console is showing zero?

Ah, well spotted. I may have misinterpreted the answer!

If the console is also showing zero, my answer stands.

If Cumulus is showing zero, but the console is showing a non-zero reading, then assuming it isn't caused by any calibration settings that you've made in Cumulus (a very small or zero multiplier, or a negative offset), then please turn on the debug log for a few minutes, and then zip up the diags folder and attach it to a reply, and include the debug.log file in the zip.

well the problem is the consule is fine the anemometer is still spining its gets windy out there and consule still doing 0km/hour

its been wind all day in Clifton do u mind i send you link? im trying to fix the Pressure as well

problem is the consule is fine the anemometer is still spining ... consule still doing 0km/hour

Then the console is not 'fine' !

Please be clear - Does your weather station display (NOT Cumulus) give a wind speed ?

yes Cumulus is not showing the wind speed
http://www.wunderground.com/personal-we ... QUEENSL315

Cumulus cannot show the wind speed if the station itself is not showing the wind speed. It appears from what you have said that the station itself is not showing the wind speed, so you have a problem with your station. What that problem might be depends on what kind of station you have. Your forum profile says you have a Vantage Vue station and a WH3081 station, but you have posted in the Oregon Scientific section of the forum. What kind of station is it that has the problem?

yeah i got the fine offset station and i didnt know the fourm oregon station and when i changed to 1.130 multiplier at 4.5m for wind after next 5 hours went down 0kph wind speed and gust and direction that what i found out there is something wrong in my bones so lol

Your WU page is now showing wind speeds for the recent past, and they seem to correspond approximately with a station near you, so whatever the problem was now appears to have gone away.