Page 1 of 1
Problem station wmr100
Posted: Sun 29 Jun 2014 1:39 pm
by giulio3x
Good morning, i write from Italy.
I have the problem with station wmr100.
After the installation of cumulus settings do not appear on the VP selection USB section, how can I do?
thank you
Re: Problem station wmr100
Posted: Sun 29 Jun 2014 1:47 pm
by steve
Please see the help - the 'VP Type' only applies to Davis stations. WMR100 stations are all USB, so you don't need tell Cumulus to use USB, there is no alternative.
Re: Problem station wmr100
Posted: Sun 29 Jun 2014 2:08 pm
by giulio3x
I understand, the fact remains that by connecting the station to the pc (windows 7 64bit), cumulus remains with all the values to 0
Re: Problem station wmr100
Posted: Sun 29 Jun 2014 2:24 pm
by steve
Please turn on the debug log and wait for a few minutes. Then zip up the diags folder and the debug.log file, and attach them to a reply.
Re: Problem station wmr100
Posted: Mon 30 Jun 2014 9:02 am
by giulio3x
after many attempts I managed to get it to communicate with the PC and I can see all the data in real time on the PC, I have a problem, but unfortunately the original wind and temperature sensors have failed and I had to take a second anemometer and a thermo-hygrometer that I placed on ch.2, unfortunately if the anemometer works and I see the data, the hygrometer as soon as I connect the station to the PC stops receiving the signal, and I always value 0 of 0 outside temperature and the humidity, I do not know what to do
attention:
I found the problem, when I connect via usb weather station, receiving the external sensor decreases and so I have to bring the external probe, thanks a greeting