Siting a Davis Vantage Vue to give sensible wind direction
Posted: Sat 11 Jan 2014 12:49 pm
I've mounted my Vantage Vue on a pole (the one that Davis sell) which is fastened to an old concrete washing-line post. It's about 10 feet above the ground with clear access and mainly flat ground on two sides (NE and SE) for about half a mile. On the NW there is a beech hedge about 8 feet high and about 10 feet away horizontally. On the SW there is a two-storey house, the middle of a terrace of three houses, which is about 30 feet away.
Although the concrete post is not vertical, I've compensated for this in my mountings and if I put a spirit level against the pole, the pole seems to be vertical in two directions at right angles, such that the bubble of the spirit level is within the guide marks, even if not perfectly symmetrically within them. I can't see the spirit level that Davis fit on the top of the sensor unit because I haven't got a high enough ladder to look down from above!
Now this may fall short of the ideal of a wind vane and anemometer mounted 30 feet high, at least 6 feet above the level of a roof or any other obstruction, but would it be responsible for the bizarre wind direction readings that I'm getting?
The wind direction value is very variable, even in light wind of 3-5 mph. The average value that Cumulus reports seems to remain steady for several hours but then over the space of about half an hour the average flips by 120-180 degrees and then remains steady at this value for several hours.
The average values seem to bear no relationship to the predicted direction from weather forecasting sites such as The Weather Outlook.
I've checked that I've got the Vantage Vue's solar cell pointing as close to south as I can manage, using a compass and checking this against an OS map. By temporarily taping the wind vane with its arrow head pointing towards the pole and away from the solar cell, I can see that the Davis console and Cumulus both report a direction of north; by then taping it with the arrow pointing towards the cell and the tail pointing towards the pole, I get a reading of south - exactly as I would expect. So it's not a communications problem.
The vane seems to move around a lot. I've seen several occasions where it remains fairly steady on one heading and then flips rapidly by 180 degrees and remains steady on the new heading. I've also seen cases where the vane has spun round and made two complete revolutions in a couple of seconds before going back to being fairly steady again.
Here's a wind direction graph from Cumulus:
http://imageshack.com/a/img203/1416/afyj.png (recorded overnight on 7 and 8 Jan 14)
Notice the rapid flip in direction that took place about 07:00!
Most of the time the reported average wind direction seems to be roughly from SE or NW, at a time when the TWO site predicts wind from SW.
I've emailed Davis for advice (they don't seem to have a discussion forum) but only had an automated response "we're very busy because of the holiday so it may take us longer than normal to reply".
Although the concrete post is not vertical, I've compensated for this in my mountings and if I put a spirit level against the pole, the pole seems to be vertical in two directions at right angles, such that the bubble of the spirit level is within the guide marks, even if not perfectly symmetrically within them. I can't see the spirit level that Davis fit on the top of the sensor unit because I haven't got a high enough ladder to look down from above!
Now this may fall short of the ideal of a wind vane and anemometer mounted 30 feet high, at least 6 feet above the level of a roof or any other obstruction, but would it be responsible for the bizarre wind direction readings that I'm getting?
The wind direction value is very variable, even in light wind of 3-5 mph. The average value that Cumulus reports seems to remain steady for several hours but then over the space of about half an hour the average flips by 120-180 degrees and then remains steady at this value for several hours.
The average values seem to bear no relationship to the predicted direction from weather forecasting sites such as The Weather Outlook.
I've checked that I've got the Vantage Vue's solar cell pointing as close to south as I can manage, using a compass and checking this against an OS map. By temporarily taping the wind vane with its arrow head pointing towards the pole and away from the solar cell, I can see that the Davis console and Cumulus both report a direction of north; by then taping it with the arrow pointing towards the cell and the tail pointing towards the pole, I get a reading of south - exactly as I would expect. So it's not a communications problem.
The vane seems to move around a lot. I've seen several occasions where it remains fairly steady on one heading and then flips rapidly by 180 degrees and remains steady on the new heading. I've also seen cases where the vane has spun round and made two complete revolutions in a couple of seconds before going back to being fairly steady again.
Here's a wind direction graph from Cumulus:
http://imageshack.com/a/img203/1416/afyj.png (recorded overnight on 7 and 8 Jan 14)
Notice the rapid flip in direction that took place about 07:00!
Most of the time the reported average wind direction seems to be roughly from SE or NW, at a time when the TWO site predicts wind from SW.
I've emailed Davis for advice (they don't seem to have a discussion forum) but only had an automated response "we're very busy because of the holiday so it may take us longer than normal to reply".