Temp, press in value 0 to start

[karlos_oviedo]

First of all apologize for my English, I have to use a translator.

my problem is this, when I start cumulus eg today at 13:40 without having been in operation since yesterday at 15:00, the values ​​shown temperature humidity pressure minima are 0.
I believe that when there is a minimum value recorded that day should not be displayed as the minimum on there at the time, right?
This is the diags file with information today and start giving error 0 at the minimum. The station had not been active since yesterday noon. The other times I can not start and fails 0 provided there been connected at 00:00 h on the same day
A greeting and thanks

http://meteocobena.es/cumulus.008

[steve]

The WMR100 has no data logger. You have to run Cumulus (or any other software) all the time - 24 hours a day - or your data will not be useful.

[karlos_oviedo]

Thank you very much for your quick response. There would be some way that the data is now displayed as 0 at the beginning, it show the value to the start and not with the dataloger since this station has not?

[steve]

Sorry, I don't understand. I can only repeat what I said before: with a WMR100, you have to run Cumulus 24 hours a day to get valid data. In particular, you cannot close it down overnight. If you do close it down overnight, you will get invalid minimum and/or maximum figures, as you have seen. The code assumes that you are running Cumulus sensibly for your station.

[Spider-Vice]

I think he means he has 0 on the low extremes. This is because of the daily rollover and yes, the fact that the WMR100 has no datalogger to fill the empty spaces and perform a successful rollover.