Page 1 of 1
Setting up data interval to match Cumulus
Posted: Wed 24 Jul 2013 9:49 am
by acousticman
I've just installed a Fine Offset/Easy Weather system and want to use Cumulus. I believe I have seen a note previously about first setting the "data interval" in the Easy Weather software to match that in Cumulus, but I can't now find the instructions. Can anyone tell me in detail how to do it, please.
Re: Setting up data interval to match Cumulus
Posted: Wed 24 Jul 2013 10:28 am
by steve
You can use my SetLogger utility, it's on the downloads page. Just unzip and run it (make sure no other software is connected to the station) and hopefully it will be self explanatory.
Re: Setting up data interval to match Cumulus
Posted: Sat 04 Sep 2021 11:17 pm
by Super-T
Setlogger works well with my WS1081 Fine offset console but it doesn't work with a spare Aercus WS1093 Fine Offset.
It seems to Connect OK but gives a 252 number when read from the Console, even after doing the SET.
Probably programming mismatch with this Aercus Model.
SetloggerFail.jpg
Re: Setting up data interval to match Cumulus
Posted: Mon 06 Sep 2021 12:39 pm
by mcrossley
We don't have the source code for SetLogger, so it cannot be updated. Though it would be a little exercise if somebody wanted to write a new version
