Hello
I just spent a few hours digging through the forum and unfortunatelly with no effect. I had to change my PC with Windows XP because of some hardware malfunction (it was restarting spontaneously) and happened to install the weather station on Windows 7 64bit. Of course I knew that old HeavyWeather would be useless, so I looked for an alternative and found Cumulus. I am really impressed with the hard work and great effect you guys achieved!
I connected the station via USB/COM connector and everything works like a charm except the pressure reading. I found out that it is ignored because of too large value:
Code: Select all
2014-04-19 22:39:24.271 : Ignoring rel pressure: 2018,5
2014-04-19 22:39:24.271 : Old value = 9999,0 New value = 2018,5 EWpressurediff = 999,0
I tried to change the Cumulus callibration file, but realised that this only changes displayed value, not the reading. So my question is: how do I set the offset of the weather station reading? It was correct on HeavyWeather and is shown correctly on the station itself.
After installing Cumulus on the old PC (I managed to complete it between restarts) and connecting it via COM port (integrated with the motherboard) I didn't get the pressure reading so I assume it is not the USB/COM connectors fault.
I'd be glad for your help