Humidity zero

[Mapantz]

I've just finished putting back my anemometer transmitter outside.

As I had the cable disconnected for a short period, the WLL doesn't send some packet data unless you power cycle the WLL. I closed CMX, then disconnected the power from the WLL, and removed the batteries for 10 seconds, then put them back in and connected the power. I waited for 2 or 3 minutes before opening CMX. I had the dashboard opened and saw the humidity drop to 0.

https://ibb.co/VpsDR2c

[freddie]

It's likely that humidity was missing from a data packet - that would cause MX to use 0.

N.B: you can put images inline in a forum topic reply. I find imgbb a bit flakey - I couldn't access the image you linked to in your post.

[mcrossley]

I think it more like it sends zero; if the data were missing it would flat line at the last value until a new value was received.

I don't suppose you had debug logging enabled at the time?

A spike setting would have prevented it.

The image in imgbb took ages to load for me, though it did eventually.

[ConligWX]

Img loads fine for me. Attached....

relative-humidty-2.png

[Mapantz]

I didn't have any logging on I'm afraid.

It registered in the realtime data going to the SQL table, but thankfully, CMX didn't register it as a 'low' figure, or the dew point either.

[Mapantz]

I just happened to look at the latest errors in the dashboard, and saw these:

Code: Select all

2023-11-09 14:46:42 - WL.com historic: Warning, no valid Solar data on TxId 1
2023-11-09 14:46:42 - WL.com historic: Warning, no valid Wind Chill data on TxId 1
2023-11-09 14:46:42 - WL.com historic: Warning, no valid Wind Chill (low) data on TxId 1
2023-11-09 14:46:42 - WL.com historic: Warning, no valid Dew Point data on TxId 1
2023-11-09 14:46:42 - WL.com historic: Warning, no valid Dew Point (low) data on TxId 1
2023-11-09 14:46:42 - WL.com historic: Warning, no valid Dew Point (high) data on TxId 1
2023-11-09 14:46:42 - WL.com historic: Warning, no valid Humidity data on TxId 1
2023-11-09 14:46:42 - WL.com historic: Warning, no valid Humidity (low) data on TxId 1
2023-11-09 14:46:42 - WL.com historic: Warning, no valid Humidity (high) data on TxId 1

[mcrossley]

And those values would be expected on transmitter #1?