Cumulus Support

Hello
I have a different problems I do not understand.
Have installed Cumulus v3.8.4 (3094) on my Oregon Scientific WMR88
but I do not get all the data to be displayed on my weather page.
What is missing is the temperature,
I see the wind, the rain, the direction but not the temperature. It can be seen in my display, I have two temperature sensors but it is not visible on the website. It only shows 0 (zero) on the temperature. FTP works because it sends data from the wind, the rain, the direction.
Where should I start troubleshooting?

Switch on debug and data logging, let it run for at least half an hour then post your mxdiags file here.

Here is the file, please tell me if you need more information !

This morning, all of a sudden, the FTP works. My weather page is updated as it should, but the temperature still does not work. I see the temperature in my weather station, I have two sensors. But it does not upload to my weather page. Has reset the weather station X number of times. No difference. During the day I will reset my two temperature sensors. I suspect that the hardware is faulty and it may be time to change the weather station.

So the station is sending temp/hum packets for channels 0 and 3.

I'll have a look at the code later - which channel are you expecting to be used as the outdoor temperature?

Today i have closed one of the thermometers, so now I only have one that uses channel 2
Everything works normal but i still missing themperatur as i said earlyer
Add new file from MXdiag

OK, after looking at the code it seems that channel 1 is used for the outdoor temperature (chan 0 for indoor, and chans 2-n are mapped to the extra temperature sensor channels).

Can you see the outdoor temp appearing against extra temperature #1?

Good morning
Unfortunately, there is a hardware error on my WMR 88 so I will shut everything down for the time being.
Thank you for all the help and support I received from you
Regard Micke