Davis VP2 wind speed
Posted: Sat 29 Aug 2020 5:39 pm
Quick question: In looking at the wind speed on the Admin Interface, my wind speed on the gauges only registers as a whole digit. It shows a decimal point with a zero after it, but the zero never changes state to something greater than zero. My PWS is a Davis VP2, running firmware version 3.80. I am running Cumulus MX 3.8.3 b3093. Is this a capability limitation of the Davis station not being able to display 1 digit to the right of the decimal point or this a limitation of the CumulusMX software? Or....am I missing something in the INI setup that would allow a decimal point reading on the gauge in the Admin Interface?
I added the 2 lines into the INI file to allow a 0, 1 or 2 place reading and I am seeing that reflected in the tables.
I added the 2 lines into the INI file to allow a 0, 1 or 2 place reading and I am seeing that reflected in the tables.