Page 1 of 1

DataloggerIP Vantage and Cumulus

Posted: Wed 24 Apr 2019 11:48 pm
by mimo57
Hello,
I have since a few weeks, a new station Weather DAVIS VANTAGE PRO2 with a DATALOGGER IP. All connected to PC-Cumulus for data processing.
Unfortunately, the PC-Cumulus suffered a disk crash and the weather data could not be recorded for about 48 hours.
I understood that the DATALOGGER IP was able to store this data for a while. But by reconnecting the PC-Cumulus, it is not, not a data received the time of the cut.
Would I fail to configure some things in, Cumulus, Vantage, or whatever?
Thank you for your feedback.

Re: DataloggerIP Vantage and Cumulus

Posted: Thu 25 Apr 2019 12:59 am
by water01
I assume, since you had a disk crash, you had to put in a new disk and rebuild the PC from the Operating System up. Or did you have backups which you restored?

If you did NOT have backups you restored and you re-installed Cumulus and have backups of the data files try using these various scenarios in the Wiki https://cumuluswiki.wxforum.net/a/FAQ#O ... t_last_ran

Re: DataloggerIP Vantage and Cumulus

Posted: Thu 25 Apr 2019 9:10 pm
by mimo57
Thank you for your reply.
1) During the crash, Cumulus was stopped.
2) The station was still connected to my network with the IP datalogger.
3) I managed to clone the KO disk, on a new disk, so no reinstallation of Windows and Cumulus.
4) Once the PC has been started, and the connection between cumulus and the console is established, resuming the reading of the data at the start time of the PC. The lapse of time between the cumulus stop and restart, no data collected, whereas they should have been stored in the datalogger.

Re: DataloggerIP Vantage and Cumulus

Posted: Fri 26 Apr 2019 1:50 am
by water01
Then I can only suggest as per the wiki you restore a backup of the complete set of files from a date prior to the crash and see if that solves the problem.