Cumulus Support

Have used Cumulus with Oregon Scientific WMR-200 for about five years. It have worked 100% without any problems. But since a couple of weeks Cumulus no longer reports min temp from my the outdoor sensor. Note that the data is available on the WMR-200 but does not appear in Cumulus.
This is what I have done to fix it:

* Changed battery in the outdoor sensor. With reset.
* Restarted the WMR a couple of times.
* Uninstalled and reinstalled Cumulus.

Any ideas here?

Mant thanks in advance.

Regards,

//Dr

All your lows seem to be in error !
... but 'This Month' looks OK

Not a lot we can do about Cumulus 1, but if you switch on debug logging and post a log file it may give a clue...

mcrossley wrote: ↑Tue 19 May 2020 8:22 am Not a lot we can do about Cumulus 1, but if you switch on debug logging and post a log file it may give a clue...

Thanks mcrossley I will do that and revert.

//Dr

mcrossley wrote: ↑Tue 19 May 2020 8:22 am Not a lot we can do about Cumulus 1, but if you switch on debug logging and post a log file it may give a clue...

Allright, I enclose a logfile

Thanks, the log appears to show everything working normally. I not quite sure though how Cumulus can be receiving and displaying the temperatures OK, recording highs and not recording lows!

You say Min temp is no longer logged. Mark says your debug log is normal.

Beteljuice says its is wrong all over your web site. When I look at your web site http://johnssonforsberg.net/weather/thisyear.htm I see what look like reasonable minimum temperatures for Sweden. Has the problem gone away?

If the problem has gone away, then the most likely cause is described at https://cumuluswiki.org/a/FAQ#End_of_Da ... r_Failures

If you disagree with me, and believe it is still not working, where is it that it goes wrong?

Let me take you through step by step.

Temperature is being read from your station to get the maximum.

The first place we see that temperature is in the monthly log, you can view (but not edit) this in Cumulus 1. Looking at a whole day's worth of lines, can you find the high and low you expect?

Is "today.ini" showing right high and low? If yes, then Cumulus 1 is correctly calculating the low. If no, then what is it reporting?

today.ini values are used for appending to "dayfile.txt". Is dayfile.txt showing right high and low?

In cumulus 1, there are lots of view screens, do they show right high and low?


If all these places show the correct figure and it is only your web site that is not showing correct figures, then I am puzzled, you appear to be using the standard web pages and not to have edited them, so I can't see any way for the preceding steps to be right, but this one wrong. The fault other people get is that they edit web templates and make a tiny mistake with a web tag or with HTML syntax.

It seems to be behaving at the moment ....