Cumulus Support

Hi Folks,

Just downloaded and started Cumulux MX on my Windows 10 machine. When I start it it says it's connected to the station, then it says it's downloading archive data, then says "PM Normal running." I assume that means Cumulus is reading data from my Vantage Vue console. However, when I connect to the console on the browser, I get nothing but zeroes on all the dials. Temp, humidity, wind, etc. All zeroes. I've gone through the wiki, FAQ, and boards and can't find anything applicable to my situation. Any help would be greatly appreciated. mxdiags.zip attached. FYI, I have wunderground data transfer enabled as well, but nothing is being sent to wunderground either.

Please attach the mxdiags.

Apologies. Attached.

I can't look at this in detail right now as I am on holiday, but it looks like it's having trouble communicating with the console. You're not trying to run any other software with the station at the same time, are you?

No worries, Steve. I've emailed Davis to delete my weatherlink 1.0 account so I can start using 2.0, and I have logged into weatherlink via the web in a couple of times to check my settings and account at the same time as I've had Cumulus running. I'll restart MX and my browser and refrain from logging in to weatherlink for the time being. I'll let you know how it goes.

Ran it for a couple of hours with nothing else running. Same result. Had debug and data logging checked. The last file in the attached mxdiags folder is the one where they were active.

It’s just sending back the same six characters regardless of the command Cumulus sends.

<lf> <cr> OK <lf> <cr>

The response OK is part of the protocol, but I can’t remember exactly when it’s used. It’s not what Cumulus is expecting.