Humidity stays on 100%

[nitrx]

My outside humidity (FO308X) is stuck on 100% in MX3005 in Cumulus 1 it gives the 'good' value 95% same as on console when I want to set the offset only 0 is accepted 0.000 gives an error this is not an integer red screen to note this applies only to the humidity.

[steve]

Yes, you can only set humidity offset in whole numbers, that's the same as in Cumulus 1.

It looks like something funny happened when you started up the new build, could you upload the diags file, please?

Does restarting fix the humidity problem?

[nitrx]

Yes, you can only set humidity offset in whole numbers, that's the same as in Cumulus 1.

It looks like something funny happened when you started up the new build, could you upload the diags file, please?

Does restarting fix the humidity problem?

Ah did not know, no restarting didn't help I als saw the temp is much too high will start again in my virtual machine and send you the diags.

[nitrx]

Oh I set the multpliers for temp and humidity to 1.7 I'm very sorry nothing wrong I need coffee The was one issue I got an error when I started the first time I became an error because the usb-device wasn't unplugged. Attached some diags (but the temp en humidity was my fault) sorry for bothering

[steve]

It shouldn't log anything if it can't connect to the station (unless you have NoSensorCheck=1 in the ini file) but it's quite likely that I haven't done all the necessary checks to stop that.