Welcome to the new home of the Cumulus Support forum.

Latest Cumulus release v1.9.4 (build 1099) - Nov 28 2014
Latest Cumulus MX release - v3.0.0 build 3044 7 December 2018. See the Wiki for download

Recommended wire to use

For discussion of DIY weather equipment - sensors, accessories, improvements to existing kit etc
Post Reply
stuee123
Posts: 1
Joined: Sun 12 Nov 2017 11:23 am
Weather Station: WMR300
Operating System: RaspberryPi

Recommended wire to use

Post by stuee123 » Sun 12 Nov 2017 11:32 am

Hi, im making a Rpi station including uv, luminance, soil temp
What im after information on is what would be the best cable to use for them as they would be no longer than 10m from the Rpi unit.

any info is greatly appreciated.

thanks.

AllyCat
Posts: 1045
Joined: Sat 26 Feb 2011 1:58 pm
Weather Station: Fine Offset 1080/1 & 3080
Operating System: Windows XP SP3
Location: SE London

Re: Recommended wire to use

Post by AllyCat » Mon 13 Nov 2017 9:36 pm

Hi,

Welcome to the forum. Are your sensors Analogue or Digital (e.g. I2C data bus) ?

10 metres it getting rather long for I2C (but possible). If analogue, what are the typical signal amplitudes and source impedance? How many cores do you need in each cable run (signal, power lines, earth, etc.)?

The choice might be between CAT5 (4 x twisted pairs) network cable or some form of screened coaxial cable. In either case the first criterion might be that it should be an "outdoor" (e.g. UV-resistant) grade.

Cheers, Alan.

Post Reply