My WH1091 has been operating very reliably since early February last year, but it's starting to report lost sensor contact every day or so, which I take as an indicator that the batteries are running low. Sooner rather than later I'll probably have to get up on the roof and change the batteries. I presume this will involve a complete memory loss on the part of the sensor system?
Is that correct, and if so, how to I get it to resume where it left off? I'm not sure where the calibration settings are stored. If in the console unit, that may be ok.
Advice appreciated.
DN
Welcome to the Cumulus Support forum.
Latest Cumulus MX V3 release 3.28.6 (build 3283) - 21 March 2024
Cumulus MX V4 beta test release 4.0.0 (build 4019) - 03 April 2024
Legacy Cumulus 1 release 1.9.4 (build 1099) - 28 November 2014
(a patch is available for 1.9.4 build 1099 that extends the date range of drop-down menus to 2030)
Download the Software (Cumulus MX / Cumulus 1 and other related items) from the Wiki
Latest Cumulus MX V3 release 3.28.6 (build 3283) - 21 March 2024
Cumulus MX V4 beta test release 4.0.0 (build 4019) - 03 April 2024
Legacy Cumulus 1 release 1.9.4 (build 1099) - 28 November 2014
(a patch is available for 1.9.4 build 1099 that extends the date range of drop-down menus to 2030)
Download the Software (Cumulus MX / Cumulus 1 and other related items) from the Wiki
WH1091 batteries getting low - how to replace and resume?
-
- Posts: 159
- Joined: Thu 03 Feb 2011 1:15 am
- Weather Station: WH1091
- Operating System: Windows 7 on a Dell Vostro
- Location: Canberra
-
- Posts: 1124
- Joined: Sat 26 Feb 2011 1:58 pm
- Weather Station: Fine Offset 1080/1 & 3080
- Operating System: Windows XP SP3
- Location: SE London
Re: WH1091 batteries getting low - how to replace and resume
Hi,fractonimbus wrote:I presume this will involve a complete memory loss on the part of the sensor system?
Not necessarily. Most data is stored in the Console (and by Cumulus) and because the external sensor module consumes very little power except when transmitting you may be able to avoid even a reset if you proceed as follows:
Remove the "sun screen", unplug the Wind cable (Rain doesn't matter, unless it's actually raining) and remove the battery cover. Wait until the TX LED flashes and immediately remove one of the AA cells and replace it with a fresh one. Wait for the next flash and change the other (or you can try changing both at the same time if you feel lucky). Refit the cover, plug in the cable(s) and refit the sun screen.
Now go to the Console and see if it's still upding. If it is then there's nothing more to do.
If after about 5 minutes you get the infamous "--" on the LCD then you need to close Cumulus, unplug the USB cable and remove (at least) one battery from the Console. Wait a minute or two, reinsert the batteries (or this might be a good time to change these as well unless you run the Cumulus 24/7), reset the date/time on the Console and you may need to change the Console display settings, relative pressure, etc..
Then reconnect the USB cable and run Cumulus. Check for any unexpected glitches in the readings (particularly rain), but there are plenty of threads, etc. (or ask here) if any records need to be edited.
Cheers, Alan.
-
- Posts: 159
- Joined: Thu 03 Feb 2011 1:15 am
- Weather Station: WH1091
- Operating System: Windows 7 on a Dell Vostro
- Location: Canberra
Re: WH1091 batteries getting low - how to replace and resume
Thanks, Alan, that was exactly the information I needed.
DN
DN
-
- Posts: 448
- Joined: Thu 05 Aug 2010 10:02 pm
- Weather Station: WS2080
- Operating System: W7
- Location: GA, USA
- Contact:
Re: WH1091 batteries getting low - how to replace and resume
Me too, Thanks Alan. Mine are about 18 months old Lithium batteries and of late I am loosing sensor contact about once or twice a day. Luckily, the transmitter is located just five feet above the ground.
I think I am going to shut down Cumulus, unplug from the USB then put the console well within range to make sure it picks up quickly. I am not too concerned about the lose of a little data.
I think I am going to shut down Cumulus, unplug from the USB then put the console well within range to make sure it picks up quickly. I am not too concerned about the lose of a little data.
-
- Posts: 159
- Joined: Thu 03 Feb 2011 1:15 am
- Weather Station: WH1091
- Operating System: Windows 7 on a Dell Vostro
- Location: Canberra
Re: WH1091 batteries getting low - how to replace and resume?
And through the wonders of Google, I found this thread again the next time I needed to change the batteries. Thanks again. System still working after 7 years.