Page 1 of 1

Strange Trend Graph

Posted: Tue Jul 17, 2018 11:31 pm
by akasonny
( moved the cumulus 1 operation to another laptop. Since, I've been getting this strange graph in the trends area. Anybody ? (see attachment)

Re: Strange Trend Graph

Posted: Wed Jul 18, 2018 6:01 am
by steve
It’s a bit difficult to tell from that thumbnail image, but it looks like it may be a problem with the data in dayfile.txt. There maybe error messages about this in the diags file, or it may be obvious from just looking at the file what the problem is. Check that the date formats are consistent, they all need to be dd/mm/yy

Re: Strange Trend Graph

Posted: Fri Jul 20, 2018 1:42 am
by akasonny
Try as I might, I couldn't see anything wonky in the dayfiles or the logs. The graph really never changes though I verified it and the T file are both in the right place both here and via FTP. Hate to reset all … think I'll just leave it as-is until I can get a better handle on it.

Thanks!

Re: Strange Trend Graph

Posted: Fri Jul 20, 2018 4:50 am
by water01
I am assuming that a Zephyr TD-1000 is an Fine Offset look alike? If that is the case I saw these sort of results when the logger interval for the new data on the new PC got set to a different value from the existing data. Try checking the logger interval using Steve's utility at the bottom of the download sections here http://sandaysoft.com/downloads

Re: Strange Trend Graph

Posted: Fri Jul 20, 2018 2:59 pm
by akasonny
Yes, correct. It is a fine offset.

I downloaded an ran Steve's Setlogger utility. It did change the timing from my manual entry of 3 minutes to 10. Could be it. I'll watch it closely. Many thanks for the suggestion. Fingers crossed.

Re: Strange Trend Graph

Posted: Fri Jul 20, 2018 3:19 pm
by steve
What have you got the daily graph number of days set to? I'm afraid I can't remember exactly where that setting is!

Re: Strange Trend Graph

Posted: Fri Jul 20, 2018 8:39 pm
by sfws
steve wrote:What have you got the daily graph number of days set to? I'm afraid I can't remember exactly where that setting is!
http://wiki.sandaysoft.com/a/Cumulus_Sc ... sion_1.9.4